Weldsale Stands

Weldsale Stands are fully welded together, and painted.  They have always been made like this.

They are made of Structural Steel Tubing and Angle Iron.

Weldsale Stands are made approximately 1/8 inch smaller (length and width) that the Platens.  This prevents the Weldsale Stands from interfering, if you wish to bolt two (or more) Platens together into larger Platen “beds”.

Weldsale Platens and Stands are designed to bolt together, and our Stands have  holes in the foot pads so you can either anchor bolt them to your floor, or install leveling pads, which will compensate for uneven floors, and allow you to easily level one Platen relative to the next, when your weldment is large enough to span several Platens.

Weldsale Platens and Stands give you a working height of 32 inches from the floor to the top surface of your Platen.  Some Customers complain that this height is too low.  We would like to point out the following:  typical leveling pads will increase the height by at least 2 inches, sometime more.  Many – but not all – of our Customers are building weldments that  build up from the table surface.  Sometimes these weldments become 1 foot or 2 feet….and sometimes 4, 6, 8 feet or higher off the table surface!  So, you can see that – sometimes – this 32 inch standard height is way too tall!!

You may custom order your stands, at whatever height you wish and at an additional cost, but before doing so, please carefully consider what you are building today, and what you MIGHT be building tomorrow.  CALL for Prices.

Scissor Lift Stands are also available but are quite expensive.  Please CALL if you wish to discuss this possibility.  ALL Scissor Lift Stands are custom made/made to order…..they are NEVER stocked.  The weight of the Platen – and a Steel Bracket to affix the Platen safely and securely to the Scissor Lift –    MUST be calculated into the Load bearing capacity of the Scissor Lift Stand.

Showing all 9 results

  • WSC-510BNS Steel Stand for 5 ft. x 10 ft. Platen

    $1,640.00
    Add to cart

  • WSC-58BNS Steel Stand for 5 ft. x 8 ft. Platen

    $1,490.00
    Add to cart

  • WSC-56BNS Steel Stand for 5 ft. x 6 ft. Platen

    $1,290.00
    Add to cart

  • WSC-55BNS Steel Stand for 5 ft. x 5 ft. Platen

    $1,230.00
    Add to cart

  • WSC-55BSU New Steel Stand for Used 5 x 5 Platens. 61 inches x 61 inches

    $1,230.00
    Add to cart

  • WSC-36DNS Steel Stand for 3 ft. x 6 ft. Platen

    $1,125.00
    Add to cart

  • WSC-44BNS Steel Stand for 4 ft. x 4 ft. Platen

    $1,030.00
    Add to cart

  • WSC-25BNS Steel Stand for 2-1/2 ft. x 5 ft. Platen

    $1,010.00
    Add to cart

  • WSC-33DNS Stand for 3 ft. x 3 ft. Platen

    $975.00
    Add to cart

Showing all 9 results